One-component, colorless, gel-like adhesive based on ethyl cyanoacrylate with the highest parameters of technical adhesive, cross-linking under the influence of moisture. Due to its high viscosity and thixotropic property, it does not run off vertical surfaces and is not absorbed by porous surfaces. Bonds very strongly metal, rubber, porcelain and many plastics in seconds.

Intended for bonding: metal, rubber, wood, ceramics, cement, hard plastics, glass, leather, plywood, aluminum, etc. (except PE, PP and Teflon). Bonds hard and elastic materials, also on vertical surfaces. Also used for bonding metal combinations "metal + rubber, plastics + rubber, paper + plywood + glass etc." And o-rings.
Features:
- universality
- high speed of gluing
- one-component
high viscosity
- glues all materials except polyolefins, PTFE, silicone rubber
- short repair time
- simple to use
- does not run off, does not drip, is not absorbed by glued surfaces
- tube 2g

Directions for use:
- When opening the tube for the first time, pierce the membrane with the upper part of the cap.
- The substrate should be clean and degreased. Degrease the surface (P-102 or P-959 Technical Degreaser).
- Apply the adhesive only on one of the surfaces to be joined.
- Do not dose glue in large amounts (the less glue, the stronger the bond).
- After applying the adhesive, connect the surfaces and press them, holding them depending on the material to be glued for 10 to 90 seconds.
- Thoroughly clean the applicator from glue residues, clear the nozzle and close the tube.